How to Use a Glove Dispenser and Apron Dispenser Together
By Smudge & Dribble | Published: 2026-10-27
Category: How-to Guides
Set up a glove dispenser and apron dispenser side by side to speed up PPE access and reduce cross-contamination. Follow these steps for a tidy, efficient station.
Quick answer
Mount a glove dispenser and an apron dispenser on the same wall near your hand-wash or entry area, placing gloves above aprons to keep sleeves and cuffs from snagging. Use the same wall-mounting method for both so the station looks neat and stays accessible.
Why place them together?
Putting glove and apron dispensers side by side cuts the time workers spend walking between separate stations. It also encourages a single donning sequence: gloves first, then apron over the gloves, which keeps the glove cuff outside the apron sleeve for easier removal later.
A combined station works well in food prep, cleaning, or light industrial areas where both items are worn together. If your space is very tight, you can stack the dispensers vertically with the glove dispenser on top.
What to check before mounting
Both the Black Metal PE Poly Glove Dispenser and the Apron Dispenser are designed for wall mounting, but you should confirm the wall surface can support the weight of a fully loaded dispenser. Drywall needs anchors; solid wood or masonry can take screws directly.
Measure the combined width of both dispensers before drilling. Leave at least 2 inches (5 cm) between them so the lids open fully and boxes can be refilled without rubbing.
Step-by-step setup
- Choose the location: Pick a wall spot near the hand-wash sink or entry door, at a height where the glove dispenser opening sits 4–6 inches above the apron dispenser. Avoid areas directly over sinks or drains to keep the dispensers dry. Check that the wall is clear of pipes or wiring before drilling.
- Mark and drill the mounting holes: Hold the glove dispenser against the wall and mark its top two screw holes. Repeat for the apron dispenser 2 inches below. Drill pilot holes and insert wall anchors if needed, then screw both dispensers in place. Use a level between the two dispensers so the station looks straight; an uneven mount can cause boxes to tilt and jam.
- Load the dispensers: Insert a box of gloves into the glove dispenser with the pull opening facing down. Unfold or roll an apron and place it inside the apron dispenser so the first apron pulls out cleanly. Do not overstuff the apron dispenser—one roll or stack at a time prevents tearing.
- Test the pull action: Pull one glove and one apron in sequence. The glove should come out without snagging the apron dispenser's lid, and the apron should not catch on the glove box below. If either pull feels tight, adjust the vertical gap or swap the positions so the taller dispenser is on top.
- Label and restock regularly: Add a small sign above the glove dispenser (e.g., "Gloves → Aprons") to reinforce the donning order. Check both dispensers at the start of each shift and refill before they run empty. A low-stock sticker on the side of each dispenser reminds staff to reorder before the station runs dry.
What you'll need
- Black Metal PE Poly Glove Dispsenser: 1 dispenser supplied; steel construction with black powder-coat finish. The rigid steel body holds glove boxes securely and won't sag over time, so the station stays aligned with the apron dispenser.
Black Metal PE Poly Glove Dispsenser - Apron Dispenser: 1 dispenser supplied; holds standard apron rolls or folded aprons. Its compact footprint lets you place it right next to the glove dispenser without taking up extra counter or wall space.
Apron Dispenser
